Back to Blog
![]() ![]() If this setting is disabled or not configured, the client uses the default value in the negotiation with Horizon Agent.Ĭonfigure the PCoIP session audio bandwidth limit If the two endpoints have different MTU size settings, the lowest size is used. ![]() This setting applies to Horizon Agent and the client. Change this value if you have an unusual network setup that causes PCoIP packet fragmentation. Typically, you do not have to change the MTU size. TCP uses the standard MTU discovery mechanism to set MTU and is not affected by this setting. The MTU size includes IP and UDP packet headers. Specifies the Maximum Transmission Unit (MTU) size for UDP packets for a PCoIP session. When this setting is modified during an active PCoIP session, the change takes effect immediately. This setting applies to Horizon Agent and the client, but the setting only affects the endpoint on which it is configured. When this setting is disabled or not configured, no minimum bandwidth is reserved. The default value is 0, which means that no minimum bandwidth is reserved. Make sure that the sum of bandwidth floors for all connections in your configuration does not exceed the network capability. Make sure that you do not over-subscribe the total reserved bandwidth for all endpoints. When you use this setting to reserve bandwidth for an endpoint, the user does not have to wait for bandwidth to become available, which improves session responsiveness. This setting configures the minimum expected bandwidth transmission rate for the endpoint. Specifies a lower limit, in kilobits per second, for the bandwidth that is reserved by the PCoIP session. Note: This setting does not affect USB directions for all device models.Ĭonfigure the PCoIP session bandwidth floor If the two endpoints have different settings, the lower value is used. The default value when this setting is not configured is 900000 kilobits per second. When this setting is configured, the setting is used as the endpoint's maximum bandwidth constraint in kilobits per second. When this setting is disabled or not configured on an endpoint, the endpoint imposes no bandwidth constraints. For example, setting a 4Mbit/s maximum bandwidth forces the agent to transmit at a lower rate, even though the setting is configured on the client. It forces the client and agent to use the lower of the two values that are set on the client and agent side. Setting this value prevents the agent from attempting to transmit at a higher rate than the link capacity, which would cause excessive packet loss and a poorer user experience. However, lowering this value will restrict the maximum bandwidth for each active session. When you expect multiple concurrent PCoIP sessions to share a link, comprising either multiple VDI users or an RDS configuration, you might want to adjust the setting accordingly. For example, with a single-user VDI configuration (a single PCoIP session) that connects through a 4Mbit/s Internet connection, set this value to 4Mbit, or 10% less than this value to leave some allowance for other network traffic. Set this value to the overall capacity of the link to which your endpoint is connected, taking into consideration the number of expected concurrent PCoIP sessions. The bandwidth includes all imaging, audio, virtual channel, USB, and control PCoIP traffic. Specifies the maximum bandwidth, in kilobits per second, in a PCoIP session. Horizon PCoIP Session Bandwidth Variables SettingĬonfigure the maximum PCoIP session bandwidth ![]() The Horizon PCoIP ADMX template file contains group policy settings that configure PCoIP bandwidth characteristics.Īll of these settings are in the Computer Configuration > Policies > Administrative Templates > PCoIP Session Variables > Overridable Administrator Defaults folder in the Group Policy Management Editor.Īll of these settings are also in the User Configuration > Policies > Administrative Templates > PCoIP Session Variables > Not Overridable Administrator Settings folder in the Group Policy Management Editor. ![]()
0 Comments
Read More
Leave a Reply. |